Hard Alloys
Tool wear and heat control for difficult alloys.
HRC 55+ / Ti / InconelCapabilities
Material Families
Materials grouped by machinability, heat sensitivity, and verification needs.
Material Control Board
Material risk grouped by behavior, not brand names.
Stainless + Heat Treat
Stability control for heat-affected materials.
Stainless / Pre-hardTechnical Plastics
Dimensional stability and finish control.
PEEK / POM / PABase Metals
Stable machining with cost control.
Al / Steel / Brass 01
Material verification uses MTR/COC records.
02
Heat treatment and lot traceability logged per program.
03
Surface finish alignment recorded before release.
Material Controls
Verification
Lot Trace
Material lots tied to inspection records.
Heat
Thermal Stability
Heat treatment and stress control tracked.
Finish
Surface Class
Finish requirements set before coating.
Material Evidence
Proof artifacts that confirm material and lot control.
EVIDENCE PACK MATERIAL VERIFY
Lot verificationMaterial gradeSource notes
Material Verification
MTR/COC verification tied to lot control.
MTR COC PDF
Lot verificationMaterial gradeSource notes
HEAT LOG
Heat cycleStability notesLot tie
Heat Treatment Log
Heat treatment and stress release records.
LOG PDF
Heat cycleStability notesLot tie
SURFACE
Surface classTest notesRelease record
Surface Proof
Finish class confirmation and test logs.
LAB PDF
Surface classTest notesRelease record
Submit for Material Control Review
Share material targets to align verification and lot control.